This internal adapter allows you to integrate two M.2 SATA SSDs into a single 2.5-inch bay, replacing a traditional platter drive. Its design facilitates the use of the SATA III controller to achieve transfer speeds of up to 6 Gbps, reducing bottlenecks in data read and write operations. The device is compatible with the TRIM function, which helps maintain the stability and performance of the installed drives.
The hardware supports RAID 0, 1, or spanning configurations to improve capacity or data redundancy, in addition to operating in JBOD mode if used with a port multiplier controller. Manufactured in red, the adapter features an open frame and dimensions of 70 mm wide, 100 mm deep, and 7 mm high, with a weight of 0.041 kg. Installation does not require additional software or drivers, as it includes all the hardware necessary for assembly.
- Install two M.2 SATA drives in a 2.5-inch bay
- Support for RAID 0, 1, spanning, and JBOD modes
- Transfer speeds of up to 6 Gbps via SATA III interface
- Compatibility with TRIM function for SSDs
- Installation without the need for additional software or drivers
- Dimensions of 70 x 100 x 7 mm and weight of 0.041 kg
